Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guida di Installazione Scaricare il pdf (Pagina 20)

Problem Solving

________________________________________________________________

16 Installation Guide - Model 65E

- AFTER THE TERMINAL HAS BEEN SWITCHED ON, THE MESSAGES

'NO ETHERNET BOARD PRESENT' AND 'CANNOT ATTACH

ETHERNET BOARD' APPEAR

This message indicates a hardware failure. Report the problem to your service

representative.

- A DOUBLE-BEEP SOUNDS

After switching on the terminal, a double beep may sound, a few seconds after

the normal first beep.

This signal indicates that keyboard initialisation has failed. Check the keyboard

connection to the terminal back panel.

It is possible for the keyboard to function correctly, despite this double-beep

signal. As a quick test of keyboard operation, enter set-up mode by pressing the

<Ctrl><Alt><Esc> keys simultaneously. If set-up mode is working, you can

ignore the double beep signal and use the terminal normally.

- ETHERNET CONNECTION INDICATOR DOES NOT LIGHT

This indicator is the green LED located next to the network connector on the

Model 65E terminal back panel.

Failure to light when the terminal is switched on may be due to any of the

following:

- the Ethernet cable is disconnected at the far end,

- the device (host or hub), to which the network cable is connected, is not

switched on,

- there is a fault on the Ethernet cable or the cable is wired with incorrect

pin assignments.

1 2 ... 15 16 17 18 19 20 21 22

Nessun commento

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guida di Installazione Pagina 20